Update for the last few months

Again, I have to confess to not being a very good blogger. It was May when I was rebuilding the cockpit well and made the last entry.

Here's a bit of a summary of what's happened since then :
Cockpit well painted inside and out.
Companionway lined with steel plate and brackets for steps in place.
Curved companionway steps laminated and epoxy'd, ready for paint and install.
Aft cabins, sole framing in place.
Master cabin en-suite framed and plated.
Engine heat exchanger mounted just forward and below the engine.
Cooling system header tank in place.
Thrust bearing supports for "Aqua-Drive" in place.
Found the ideal propeller on Trade-Me (25x18).
Prop shaft cut to length and new taper & thread machined.